A Step-By-Step Guide to Cutting a Girl’s Hair Like a Pro

Download Article

Forget the salon with our easy-to-follow instructions

Co-authored by Jenny Tran

Last Updated: December 20, 2023 References

Download Article

Trimming Hair

|

Cutting Layers

|

Cutting Bangs

|

Video

|

Expert Q&A

|

Tips

You don't always have to pay for an expensive haircut. Cutting a girl's hair can be done with a few basic tips, guidelines, and proper scissors. It does take some skill to perform a quality cut, but if you feel up to the challenge, try giving a cut or trim to a girl in need.

Things You Should Know

Start by cutting clean, brushed hair with sharp scissors at the back-center of the hair. This will serve as your guide as you make your way toward the sides and front.
Trim the sides to the length of the guide piece you cut at the back of the head. Move your guide piece to either side of the head as you trim your way around.
Check that all hair is the same length by bringing all the hair to the front and smoothing it down flat. If a piece is a bit longer, simply trim it to match the rest.

Method 1

Method 1 of 3:

Trimming Hair

Download Article

1
Start with washed hair. The hair should be clean and damp when cutting. After the hair is washed, towel dry it to remove excess water, and then comb out any knots.^{[1]
X
Research source}
- Comb from the ends, and work your way up to the root to work out knots. This will prevent damage to the hair and will put less strain on the scalp.^{[2]
  X
  Research source}
- You should always use a comb for detangling. Don't use a brush.
For a quality haircut, you will need to be in a well lit area. The girl who is getting the haircut needs to be sitting down straight, preferably in a chair high enough so the stylist does not need to lean down.

Advertisement
3
Comb the hair. The hair should be combed straight back first, and then parted in the place it normally is. If the hair is worn with a middle part, do that. If the hair has a side part on the left or right side, do that. The hair will typically fall where it is trained to be.^{[3]
X
Research source}
- Check behind the ears for snarled or stuck hair. All of the hair needs to be combed straight down for a proper cut.^{[4]
  X
  Research source}
The ideal scissors to use would be stylist scissors specifically designed for hair cuts. Dull scissors will not cut the hairs cleanly, and they might create split ends. Additionally, dull scissors will bend or push the hair down before making a cut, resulting in a hairline that looks uneven.^{[5]
X
Research source}
5
Start cutting in the back at the center. This will serve as your guide as you make your way towards the sides and front. You will use the back piece as a reference as you are cutting around the sides to keep the trim even.^{[6]
X
Research source}
- Pull up the back section of hair, and bring the ends through your forefinger and middle finger. You should have about 1/2 inch to two inches sticking out from your fingers. Cut straight across. For a softer look, you can trim up into the hair, holding the scissors at a 45 degree angle.^{[7]
  X
  Research source}
- The amount of hair you cut depends on how far up the damage goes, but typically it will be about 1/2 inch to two inches. Start by cutting less, and then go back to cut more if desired.
- Have the person lean their head forward slightly when cutting the back to help you perform a more even trim.^{[8]
  X
  Research source}
Work your way from your guide piece to the side. When cutting the hair that lays on the shoulder, have the person slightly lean their head to the opposite side. This will bring the hair up to help you cut more evenly.^{[9]
X
Research source}
Once you make it to the front of one side, go back to your guide piece in the back, and begin cutting the opposite side. Have the person lean their head to the opposite side you are cutting, and be sure to reference the guide piece the entire time.^{[10]
X
Research source}
8
Check the length on both sides. Once you are finished, come to the front, and bring the hair from both sides between your fingers. Pull them down and flat, and look to see if they are the same length. If one side or piece is longer, go ahead and trim it appropriately.^{[11]
X
Research source}
- If you're cutting their hair in front of a mirror, it's easier to check the evenness by standing behind the person and looking at their reflection in the mirror.
Remember, as the hair dries, it will slightly shorten. If you notice any uneven pieces after the hair is dry, dampen the area, and even it out with scissors.

Method 2

Method 2 of 3:

Cutting Layers

Download Article

1
Wash and towel dry the hair to be cut. The hair should be clean and damp while it is being cut. Comb all of the tangles out, and apply leave in conditioner if needed.
- Decide on the length you want your hair to be before it is pinned up.^{[12]
  X
  Research source}
2
Divide the hair into sections. The layers on each side should be the same length, and to help do this, it is important to divide each side into symmetrical sections. The trick is to pull away from the places you want layers by combing each section at an angle down towards the face from the back. Here are the sections you will pin:^{[13]
X
Research source}
- As you divide your sections, twist each 1 into a tiny bun. Then secure the bun with a duckbill hair clip until you're ready to cut that section.
- Pin together the "top box" section. Use a comb to make a part on the top left and right side. Use the end of the eyebrows as a guide for how far over the part should be. Divide this section in half. One part will be from the crown of the head to the forehead, and the second part will be from the crown of the head and reach to the middle back section of your head. This hair will be combed forward and be section off in the front. The back of the hair from the middle down will not be layered. It can be left loose or pinned back.^{[14]
  X
  Research source}
- Divide the right and left front sections. These sections will start at the temples and end at the ear. Start with the comb at the back of the head, and angle down towards the bottom of the ear.^{[15]
  X
  Research source}
3
Angle your cuts. When you cut or trim hair, you will angle the scissors up and at a 45 degree angle, and use the tip of the scissors to cut small pieces at a time. This will create uneven edges that will give the hair a more natural look.^{[16]
X
Expert Source

Jenny Tran
Professional Hair Stylist

Expert Interview. 31 August 2020.}
- As you are cutting, you want to avoid bringing the scissors straight across the bottom. Instead, slightly pull the scissors away after each cut before cutting the next piece.
4
Start with the front "top box." Take out the clip from the top front section. Make sure the hair is still damp and completely combed out. Lift the hair at a 90 degree angle to your head, holding it between your forefinger and middle finger. It is important to cut the hair at an angle so it falls more naturally. Slide your fingers toward the ends until they reach the length you want the layer to end. You will cut the hair that is sticking out from your fingers.^{[17]
X
Research source}
- Cut a little longer than you want the layers to be to allow room for error. Keep in mind that hair shrinks when it dries.^{[18]
  X
  Research source}
- Common layers are cut right below the earlobe, or just above the jawline to help frame the face. It's a good idea to drop 1 section of hair down, and then cut it at the desired length of the layer. Then, you can pull that hair back up and use it as a guide for the rest of your hair.
5
Trim the front left section. Next, take out the clip from the left section of hair. Brush through the hair, and pull it up toward the top section. Allow some of the hair to fall away so that you can maintain some of the longer length. Holding the left section between your fingers, trim the hair to your desired length. Remember to trim at an angle to create a more natural look.^{[19]
X
Research source}
- If necessary, you can always trim some of the fallen hair to add to your layer.
Next, take out the clip from the right section of hair. Brush through the hair, and run your fingers through the section at a 90 degree angle from the head. Bring your fingers down to the side of the face where you want the layer to end. Make sure it is even with the side you just cut. Use one hand to pull the layer that was just cut down so you can match up the two sides. When you are ready, cut the hair extending from your fingers.^{[20]
X
Research source}
When you are finished with each section, check the length of the layers. Line them up on both sides to see if they are symmetrical. If one side or piece is shorter than the other side, go back and trim it shorter. When you make adjustments, take off small amounts at a time so you don't end up making the hair shorter than desired.^{[21]
X
Research source}
Use a round brush as you blow dry to bring out the layers. Twist the brush inward as it dries to bring the shorter layers in with the longer layers. If you notice an area that needs to be cut shorter, remember to get all of the hair damp again before you cut it. If you only dampen one side, you will not be able to properly match up each side because the wet hair will appear longer than it will be once it dries.

Method 3

Method 3 of 3:

Cutting Bangs

Download Article

1
Prepare your bangs. Whether you are trimming bangs, or creating bangs for the first time, the front section of hair should be dry and combed out before cutting. Use a comb to section off only the area you wish to cut, and put the rest in a ponytail or clipped out of the way.>
- Your bangs should not extend further than your brow line. Also, they'll look best if they follow a triangle pattern with the top point being in the center of your hair about 3 inches (7.6 cm) above the bottom of your hairline.
- A common problem when cutting bangs is cutting them too short. This is why bangs are best cut when hair is dry.^{[22]
  X
  Expert Source
  
  Jenny Tran
  Professional Hair Stylist
  
  Expert Interview. 31 August 2020.}
- Cut the bangs longer than you ultimately want them. This way, you can figure out the shape you want, and go back to make adjustments.
Bangs are not cut straight across. Instead, they curve down towards the temples to help create a frame for the face. However, it depends on the look your are going for.
If you are simply trimming bangs, you will bring the comb through underneath the bangs where you want them to end. If you are making new bangs, use the comb to section off the hair you want to cut. Depending on how thick the hair is, bangs usually start right in front of the middle of the crown and angle downward on both sides towards the temples. You can play around with the look you prefer.
Make a straight cut across your forehead, directly below the comb. Work your way toward one side, following the curve. By starting in the middle, you will have more control over how short the bangs end up. Angle the scissors down when working your way to the edge to create a gradual curve. Once you have one side finished, bring the scissors back to the middle, and cut the other side.^{[23]
X
Research source}
Use your finger tips to pull down on the hair between your forefinger and middle finger. See if the bangs are the same length on each side. If they are not even, carefully trim the side that is longer. Cut tiny amounts at a time so you do not accidentally cut the longer side shorter, which may result in bangs that are shorter than you want.
After your bangs are even, hold the scissors vertically at a 45 degree angle. Trim the edge with tiny cuts up into the hair, softening the look. Be careful not to remove any of the length.
Use a makeup brush or blow dryer to get rid of those tiny trims. If the bangs do end up shorter than you were going for, do not worry. Hair grows at a rate of 1/2" per month on average, and that makes a big difference when it comes to bangs.^{[24]
X
Research source}

The Takeaway: Trimming a Girl’s Hair

Wash, comb, and lightly dry the girl’s hair so it’s damp. Part her hair how she likes and take a small section at the back between your forefinger and middle finger. Use sharp stylist scissors to cut the hair in a straight line to her desired length and slowly work your way around her head.

Expert Q&A

Search

Add New Question

Question

Is it best to cut bangs wet or dry?

Jenny Tran
Professional Hair Stylist
Jenny Tran is a Hair Stylist and the Founder of JT Hair Lab by Jenny Tran based in the Dallas, Texas metro area. With over seven years of professional hair styling experience, Jenny specializes in hair coloring, haircutting, and hair extensions. JT Hair Lab is an authorized carrier of R+Co and of Milbon and is committed to using products with quality ingredients.

Jenny Tran

Professional Hair Stylist

Expert Answer

Always cut bangs when the hair is dry. It's really common to cut bangs too short. Since wet hair shrinks up when it dries, it's hard to cut bangs the right length if the hair is wet.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 0 Helpful 3
Question

Should I let my little girl shave her hair?

Community Answer

If she wants to, then yes, but warn her she may regret it a lot. Ensure she wears beanies to keep her head warm. If she loves her hair, don't let her do it. She will regret it.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 5 Helpful 17
Question

My daughter was playing with scissors with her friend and a huge chunk was taken off on one side most of her hair is stomach length and some is now shoulder height and she wont let me cut the rest?

Community Answer

I recommend taking her to a proffesional hair stylist with experience working with children. They can often work miracles and fix even the biggest of mistakes. An option that may be suggested is layering the hair to make it look more natural. If your daughter won't let you touch her hair, you could at least try someone else.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 3 Helpful 16

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Tips

Keep your hair damp during hair cuts and trims. Keep a spray bottle nearby to moisten your hair if needed.

Thanks
Helpful 15 Not Helpful 5
Use scissors with caution.

Thanks
Helpful 12 Not Helpful 6
Cut small pieces at a time, and do not rush. You can always come back and cut a piece again later, but you can't stick it back on once it's gone!

Thanks
Helpful 10 Not Helpful 6